JC Industries Feed Water Turbine Pump, Model B, Albrizac

$2,925.00$3,150.00

Clear
SKU: N/A Category:

Description

The Model B pump is fitted with the same fluid ends as the Model A. The model B motors are available in 2 HP and 3 HP in total enclosed frames, 208-230/460 3phase voltage in special order. Other voltage motors are available on special order.

Inlet is 1-1/4″ NPT and outlet is 1-1/2″ NPT

Model Volume @ 100 PSIG Motor HP
B8 8 2
B10 10 2
B12 12 2
B14 14 3
B16 16 3

All pumps are fitted with mechanical BUNA-N seals propylene (E.P.) or Viton for higher temperature applications are available as well. The matting ring is of porcelain material with a carbon primary sealing ring and stainless steel spring. The temperature ranges are -40C to +105C for BUNA-N seal, -45C to +150C for E.P. and -30C to +205C for Viton.The end plate is made of a bronze material which allows some expansion without cracking when frozen due to incomplete draining. This end plate has been test proven in Western Canada’s cold climate in the Drilling Industry over the past 8 years. Of 700 plus end plates installed and in use under severe winter conditions, none have been returned due to cracking or failing.

Every pump is inspected and factory tested before delivery.

Solid bronze liners drilled and grooved for complete draining. The inner liner has a special design feature which allows for pressure reduction, better circulation and cooling to the mechanical seal. The impeller hub is grooved for easy removal with a “C” clamp to access the mechanical seal.

The shafts are of stainless steel fitted with sealed ZZC3 bearings and secured in a locked position with bronze adjusting nuts and a locking screw.

For low and high pressure boiler, circulation, and condensate return. When not in use pump should be drained and purged with anti-freeze to prevent frost damage under freezing conditions.

Albrizac pump has a 1 year manufacture warranty against all defects including material and labor. Incorrect adjustment, running without water material will cause premature wear or pump failure and is not covered under warranty.

 

 

Additional information

Model

A8, A10, A12, A14, A16

Motor

None, 3 Phase, 208-230/460 volt